Frigidaire Gallery GLHT186H Use And Care Manual: Household Water Supply To Refrigerator; Connecting Household Water Supply
While most city frigidaire refrigerator ice maker hook up require that a licensed plumber install the necessary connections at the water supply line, connecting a Frigidaire's ice maker to the water line is a process you can do with just a few tools. Before you begin the project, turn off the power to the refrigerator to avoid any chance of electrical shock. You'll need an installation kit with copper or stainless steel braided tubing to complete the process.
Turn off the water supply to the sink. Let the water run from the faucet to flush water from the line. Connect the water supply to the braided tubing using the connector the plumber mzker. Tighten the connection with an adjustable wrench. Do not over tighten the connection. Set the open end of the tubing inside of a bucket. Turn the water supply on. Open the valve to the ice maker line. Allow some water to run through the line to flush it out. Turn off the valve to the ice maker line.
Locate the water inlet valve on the back of the refrigerator. Remove and discard the plastic cap that covers it. Slide the brass compression nut that comes with a copper supply line installation kit over the water supply line. Push the ferrule, or sleeve, from the kit onto the line. Slip the ferrule into the valve inlet and use your fingers to tighten the compression nut. Skip the assembly jook the nut and ferrule if you are using stainless steel tubing as pu are already on the tubing.
Set the compression nut over the valve inlet and finger tighten it. Loosen the screw that holds the steel clamp on the back of the refrigerator. Slide the copper tubing inside the clamp and re-tighten the screw. Skip this step if you are using stainless steel tubing. Arrange it on the back of the refrigerator so it can't rub against anything. This is not necessary if you use stainless steel tubing. Turn the water supply valve on again. Examine both the water supply connector and the water inlet valve on the refrigerator for leaks.
Tighten the respective connectors a bit more, if necessary. Plug the refrigerator into its power source. Slide the refrigerator into position. Prime the water supply line by holding a glass under the water dispenser. Allow water to flow into the glass for approximately 4 minutes. Empty the glass as it fills. Skip this step if your refrigerator doesn't have a water dispenser on the door. Turn the ice maker on if the green light is not visible above the "Ice Refdigerator indicator on the operator panel.
Frigidaire refrigerator ice maker hook up and hold the button until the light turns green. On some models you lower refrigefator metal bar beside the ice maker to start its operation. Replacing a stainless steel refrigerator door rrefrigerator similar to replacing any other type of refrigerator door. With stainless steel, you need to In older homes, you are likely to encounter a black colored drain pipe, which signifies ABS piping.
Today, it is difficult to Installing an ice-maker kit for your Kenmore refrigerator can save you the time and hassle of using ice cube trays. Connecting water lines is a necessary part of household plumbing for many homeowners. Many people use flexible braided stainless steel hoses to Many side-by-side frigidaiire come with water and ice dispensers in the door.
You should prime the water system in the refrigerator after By Denise Brown eHow Contributor. Other People Are Reading How to Connect a Water Line frigidaire refrigerator ice maker hook up a Frigidaire Refrigerator How to Install a Frigidaire Ice Maker. Frigidaire refrigerator ice maker hook up the Ice Maker in a Frigidaire. When to Replace a Frigidaire Refrigerator Water Filter.